研究開発におけるマルチフィジックスシミュレーションの具体例
さまざまな業界のエンジニア, 研究者, 科学者がマルチフィジックスシミュレーションを使用して革新的な製品の設計とプロセスを研究および開発しています. COMSOL カンファレンスで発表したテクニカルペーパーやプレゼンテーションからインスピレーションを得てください. 以下の選択項目を参照するか, クイック検索ツールを使用して特定のプレゼンテーションを検索するか, アプリケーション領域でフィルタリングします.
COMSOL カンファレンス 2024 論文集を見る
A device for monitoring the oxygen consumption of cells has been developed, which consists of two parts; a cell culturing platform (CCP) and an oxygen sensing chip. The CCP possesses inlet and outlet pipes to direct the fluid under the test to the cell culturing chamber through the inlet ... 詳細を見る
Multiphase flow in a microreactor was studied numerically for two immiscible liquids. Validation of the model was sought by simulating the flow behavior and mass transfer characteristics of a neutralization reaction described in the literature. Contact angles, interfacial tension and the ... 詳細を見る
This paper presents the results of modeling of a microreactor with three inputs geometry (or crow's-feet), in relation to distributions of velocities and concentrations. The objective of this work is the study of this kind of geometry with relation to fluid dynamics behavior, improving ... 詳細を見る
In this numerical study, surface acoustic waves (SAWs) are evaluated as a potential disruptive flow technology for enhancing heat transfer in microchannels. Using COMSOL Multiphysics® software, the physics governing acoustics, single-phase-fluid flow and heat transfer are coupled. The ... 詳細を見る
This paper presents the 3D model of pressure distribution in the process of magneto-rheological flow finishing. The effect of working gap on pressure distribution is studied using COMSOL Multiphysics® software. Also, the effect of different viscosity of fluids on development of pressure ... 詳細を見る
Flexography is a roll-based mass printing process used in manufacture of printed products such as sensors, self-cleaning surfaces, and flexible electronics. Flexography involves inking of a stamp wrapped around a roller, and the transfer of ink on the stamp surface to a printing ... 詳細を見る
Microcontact printing is a method for depositing patterns of thin films or molecular monolayers on surfaces using a polydimethylsiloxane (PDMS) stamp for selective mechanical contact (Figure 1). Undesired deformation of the stamp features during printing affects printed pattern quality. ... 詳細を見る
In our study of chaotic mixing, 3D velocity measurements (u,v,w) are required for evaluation of a micro mixer using a mix-prediction algorithm. The hybrid approach presented here combines 2D measurements, an imperfect numerical model, and appropriate fitting parameters. Because our ... 詳細を見る
AC electrothermal (ACET) micropumps are based on the temperature gradient caused by Joule heating or an external heat source in the bulk of an electrolyte. In this paper, a 2D simulation was performed to study the effect of substrate thickness and material (glass and silicon) for an ACET ... 詳細を見る
Flow focusing microchannels are widely used in droplet generation mechanisms. In this paper, the effect of linear vibration on the flow pattern in a flow focusing structure and the corresponding formed droplets were numerically investigated using COMSOL Multiphysics® software. The ... 詳細を見る