研究開発におけるマルチフィジックスシミュレーションの具体例
さまざまな業界のエンジニア, 研究者, 科学者がマルチフィジックスシミュレーションを使用して革新的な製品の設計とプロセスを研究および開発しています. COMSOL カンファレンスで発表したテクニカルペーパーやプレゼンテーションからインスピレーションを得てください. 以下の選択項目を参照するか, クイック検索ツールを使用して特定のプレゼンテーションを検索するか, アプリケーション領域でフィルタリングします.
COMSOL Conference 2024 論文集を見る
The present paper describes the development of a full FEM model for linear array high performance 5MHz ultrasound imaging transducer. As a preliminary design, a mono dimensional electro-acoustical KLM model was realized, then the complete FEM was developed and optimized. The optimized ... 詳細を見る
This work is concerned with systems possessing cyclic symmetries. In particular, we concentrate on the case in which the medium possesses infinite order cyclic symmetry, while the constitutive relations have cyclic symmetry of a lower order. We investigate the interactions between modes ... 詳細を見る
Metacomposites are new class of materials with unusual properties that can be engineered using existing materials with usual properties. The unusual properties of metacomposites are derived from the structure, analogues to atomic arrangement in crystal lattice. These material exhibits ... 詳細を見る
We perform EM simulations of a low-pass microstrip filter consisting of a cross-junction open stub and two unit sections implemented as defected ground structures (DGS). The defect introduced by unit sections corresponds to an etched lattice on the copper backside ground plane. The ... 詳細を見る
VRALA is the ideal candidate as an Adaptive Optics actuator at visible wavelengths. Its electric characteristics variations, suitable current commands, and an effective magnetic circuit geometry provide a 2 kHz correction bandwidth and a 25 mm actuator density. The magnetic core allows ... 詳細を見る
The reciprocating paddle cell is a known practical method for depositing alloy films on wafer substrates. Recently, the mass transfer boundary layer within an industrial wafer plating cell was studied based on the measurement of limiting current. It was indicated that a shear-plate fluid ... 詳細を見る
The discharge properties in low pressure inductively coupled Ar/CH4 plasmas operating at an RF frequency of 13.56 MHz and total gas pressure of 20 mTorr are studied in this work. The calculation of gas flow is performed in coupling with the plasma simulation. The gas flow rate is varied ... 詳細を見る
In oil and gas industries, electrical heaters are often used to control the internal pipe temperature. One important criterion for such test, is to maintain a uniform temperature range during the test. The objective of this study was to evaluate the heat transfer of one design of the ... 詳細を見る
Dr. Ivar Kjelberg is Senior Project Manager for Mechatronics in the Systems Engineering Division of CSEM SA in Neuchâtel, Switzerland. He obtained the diploma as \"Ingénieur Physicien\" from the Ecole Polytechnique Fédéreale EPFL in Lausanne, Switzerland in 1979, and a PhD at the local ... 詳細を見る
Loudspeaker simulation is used to inform the designer as to the performance of a design. In recent years the Finite Element Method (FEM) has been used to model the mechanical and acoustical attributes of a loudspeaker with varying success. This paper shows how a model that incorporates ... 詳細を見る