技術情報とプレゼンテーション

Anti-roll bar or stabilizer bar is a critical component for vehicle’s roll stiffness. This plays a major role in cornering and overall vehicle dynamics. Various methods can be used to calculate stiffness of roll bar at design stage. A simple formula-based method is used calculate the ... 詳細を見る

An accelerometer detects acceleration and tilt of a device. There are several areas where accelerometers are in use, e.g. aerospace, navigation, automotive industry, electronic gadgets etc. According to different working principle, there are different types of accelerometer, e.g. piezo ... 詳細を見る

Lithium ion battery electrodes are porous composite film made up of two or three different types of solid material. Typically using the fabrication of the electrode, the solid powders (active material, binder and in most cases a conductive active) are dispersed in a solvent like NMP and ... 詳細を見る

In this, FEM simulation of the interdigitated electrodes (IDEs) device using COMSOL Multiphysics® is presented. In this study, the effect of meshing sequence on the performance of IDEs device was evaluated using normal as well as adaptive mesh refinement. The key parameters such as of ... 詳細を見る

Arches being one of the most aesthetic and stable form of structural elements, have been constantly used since hundreds of years in various form of constructions be it buildings, bridges or any other structural system. Though, common use of reinforced concrete framed structures has ... 詳細を見る

Numerical investigations of magnetorheological elastomer millimeter-scale robots capable of undulatory swimming under magnetic body torques are realized for the first time in low Reynolds number condition using AC/DC, CFD, Structural Mechanics modules in COMSOL Multiphysics®. The ... 詳細を見る

Active fluid jet polishing is a sub-aperture polishing process used in the optical fabrication of complex surfaces. Correction of surface irregularities during the polishing process is a challenging process. Quality of optical surface depends on smoothing action during fine and ... 詳細を見る

This paper presents numerical investigation of electronic thermal control using heat sink for integrated circuit (IC) chip cooling under forced convection in a horizontal channel. Steady state, three dimensional, incompressible, laminar forced convection cooling of chip attached with ... 詳細を見る

Renewable energy sources such as solar and wind are intermittent in nature. Their effective utilization requires efficient, low cost energy storage systems to complement energy harnessing systems. The rechargeable flow batteries have emerged as the most suitable candidates due to their ... 詳細を見る

Surface Acoustic Wave devices are classic examples of Micro Electro Mechanical Systems (MEMS). These devices basically utilize inter-digitated electrodes (IDE) and a piezoelectric layer deposited over a substrate. The input IDT is supplied with alternating voltage and because of this, ... 詳細を見る