Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Wall Boundary Condition

Posted 2011/09/28 12:19 GMT-4 Microfluidics 0 Replies

Mansoor Nasir
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have used the fluidic models extensively and always have specified a no-slip condition on the walls. I am now trying to understand what would happen in my channels if there WAS a slip at the walls.

Can someone explain the different options available for slip at the walls? For example what does choosing 'Slip' actually specify for the wall because there are no options available for lengths or velocities as in 'sliding wall' or 'slip velocity'?

Appreciate any insight you can give. Thank you
0 Replies Last Post 2011/09/28 12:19 GMT-4
COMSOL Moderator

Hello Mansoor Nasir

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content