Modelling Dipole Antenna

Please login with a confirmed email address before reporting spam

I tried to model dipole antenna (by following comsol guidelines). While following the steps, Impedance Boundary conditions, I can't select boundary from the geometry. The geometry selected looks like this. Please do tell me where I went wrong. .



2 Replies Last Post 2023/11/02 9:20 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 6 months ago 2023/11/02 8:40 GMT-4
Updated: 6 months ago 2023/11/02 8:40 GMT-4

Could it be that you have hidden the boundary you are trying to select? It looks that way on the screenshot you attached.

Jeff

-------------------
Jeff Hiller
Could it be that you have hidden the boundary you are trying to select? It looks that way on the screenshot you attached. Jeff

Magnus Ringh COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 6 months ago 2023/11/02 9:20 GMT-4

Hi,

I think that Jeff is right. Another tip is to use the mouse wheel to move between all boundaries or domains in a 3D geometry that the mouse is pointing toward. It can make it easier to select hidden parts of the geometry.

Best,

Magnus

Hi, I think that Jeff is right. Another tip is to use the mouse wheel to move between all boundaries or domains in a 3D geometry that the mouse is pointing toward. It can make it easier to select hidden parts of the geometry. Best, Magnus

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.