Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Consistent error while computing the results for the model built

Please login with a confirmed email address before reporting spam

Sir..

I am working on a building model with pipes embedded in the ceiling for Concrete Core Cooling. I am getting a continuous error even after many corrections. The error says

Failed to find consistent initial values.
Last time step is not converged.

I have made the corrections suggested by you in the above comment. But still, the problem persists. I request you to have a look of the model in the link and help me out if you can find any errors rolled out.

www.sendspace.com/file/d1vtq3

Thanking You sir...

Nithin

1 Reply Last Post 2013/02/18 1:07 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013/02/18 1:07 GMT-5
Hi

complex multi-physics models can be tedious to get running, particularly when you start from all default "0" initial conditions, mixing HT and CFD. One way is to use a stationary solver to set the initial conditions, then run a time series from there

--
Good luck
Ivar
Hi complex multi-physics models can be tedious to get running, particularly when you start from all default "0" initial conditions, mixing HT and CFD. One way is to use a stationary solver to set the initial conditions, then run a time series from there -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.