Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

About the complex value in the solution of RF model.

Posted 2010/06/25 5:34 GMT-4 0 Replies

Liu Feng
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi , everyone . I met a problem when using the RF model.The problem is : when I follow the example in model lib which is RF_Module/Optics_and_Photonics/step_index_fiber,I noticed that in the post processing section, I need enter 45 degree in solution at angle,why need I enter 45 there? If not do , the real part of Ez is zero.Only image part of Ez has values. That is a little weird in physics, it is a model to calculate the mode in setp_index_fiber, all the value should be real in fact. Otherwise, if I calculate some other modes that in the solution of COMSOL the Ez both has image and real part. What should I do to get the physically real part?Thank in advance.
0 Replies Last Post 2010/06/25 5:34 GMT-4
COMSOL Moderator

Hello Liu Feng

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content