Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.
-
How to put the result of the first model as an initial condition (or initial value) into the second model
read3 Replies 1315 ViewsVersion 5.6 Studies & Solvers
Tao Zhou posted 3 years ago reply 3 years ago by Mark Harradine
-
0 Replies 109 Views
Anton Dyshlyuk posted 3 years ago
-
0 Replies 91 Views
Version 6.1 Computational Fluid Dynamics (CFD)Studies & SolversPhysics Interfaces
Anurag Rajan posted 3 years ago
-
2 Replies 403 Views
Version 6.1 Optimization
Hendrik posted 3 years ago reply 3 years ago by Hendrik
-
2 Replies 291 Views
Version 6.1 Acoustics & VibrationsModeling WorkflowPhysics Interfaces
Nagendra s posted 3 years ago reply 3 years ago by Nagendra s
-
2 Replies 94 Views
Version 6.0 GeneralGeometry
Ibrahim posted 3 years ago reply 3 years ago by Ibrahim
-
2 Replies 2890 Views
ElectromagneticsMaterials
Abbas Shoker posted 3 years ago reply 3 years ago by Edgar J. Kaiser
-
0 Replies 205 Views
Version 5.4 Wave OpticsMeshStudies & Solvers
Ali Vafa posted 3 years ago
-
0 Replies 305 Views
Vincent Thlija posted 3 years ago
-
0 Replies 155 Views
Porous Media FlowModeling Workflow
Ahmed CHETTI posted 3 years ago
