Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.
-
Plot "set of curves" after parametric sweep with two variables (stationary study, heat transfer)
read7 Replies 13451 ViewsVersion 4.1 RF & Microwave Engineering
Simon S. posted 1 decade ago reply 1 decade ago by J. Zhang
-
1 Replies 1648 Views
Alejandro García posted 1 decade ago reply 1 decade ago by L. Queval
-
1 Replies 1463 Views
Harsh Dhingra posted 1 decade ago reply 1 decade ago by Harsh Dhingra
-
2 Replies 4064 Views
Version 4.0a Low-Frequency ElectromagneticsStructural Mechanics
ayan banerjee posted 1 decade ago reply 1 decade ago by Ali
-
5 Replies 4220 Views
Giorgos Kourakos posted 2 decades ago reply 1 decade ago by Ivar KJELBERG
-
6 Replies 16588 Views
Yang Gao posted 2 decades ago reply 1 decade ago by Ivar KJELBERG
-
1 Replies 2138 Views
Zhiyong Si posted 2 decades ago reply 1 decade ago by Praveen Chalasani
-
8 Replies 2793 Views
Pranith Tummala posted 1 decade ago reply 1 decade ago by Uttam Pal
-
2 Replies 3497 Views
Version 4.0a Fluid & HeatComputational Fluid Dynamics (CFD)Modeling Tools & DefinitionsParameters, Variables, & FunctionsStudies & Solvers
Ranjeeth Naik posted 1 decade ago reply 1 decade ago by Ivar KJELBERG
-
2 Replies 2943 Views
Low-Frequency ElectromagneticsRF & Microwave EngineeringMeshResults & VisualizationStudies & Solvers
Fengyuan Sun posted 1 decade ago reply 1 decade ago by Ivar KJELBERG
