Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Command to extract the number of selection

Posted 2016/10/21 17:29 JST 2 Replies

Harutaka Kawamura
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, I'm working with livelink for Matlab. Is there any command to extract the number of domains in the geometry?
2 Replies Last Post 2016/10/29 1:00 JST
Lars Gregersen COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2016/10/28 21:05 JST
Hi

This should work:
model.geom('geom1').getNDomains

All such low level methods are mentioned in the Programming Reference Manual in the section titles "Geometry Object Information".


Hello, I'm working with livelink for Matlab. Is there any command to extract the number of domains in the geometry?



--
Lars Gregersen
Comsol Denmark

Hi This should work: model.geom('geom1').getNDomains All such low level methods are mentioned in the Programming Reference Manual in the section titles "Geometry Object Information". [QUOTE] Hello, I'm working with livelink for Matlab. Is there any command to extract the number of domains in the geometry? [/QUOTE] -- Lars Gregersen Comsol Denmark
Harutaka Kawamura
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2016/10/29 1:00 JST

Thank you so much. That's exactly what I have been looking for.
Thank you so much. That's exactly what I have been looking for.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content