Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

plots of selected surfaces in 4.1

Posted 2011/02/18 9:30 GMT-5 Version 4.1 1 Reply

Maria Eleni Mitzithra
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone!

i would like to ask how i could select in a geometry, specific surfaces in order to plot them in 4.1a and then export these particular data?

Thank you in advance

Marilena
1 Reply Last Post 2011/02/18 9:40 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011/02/18 9:40 GMT-5
Hi

try a right -click on the Results - Data Sets node and select thereform ;)

--
Good luck
Ivar
Hi try a right -click on the Results - Data Sets node and select thereform ;) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content