Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Integrating a dependent variable over a line
Posted 2011/07/05 21:32 GMT-4 MEMS & Nanotechnology, Fluid & Heat, MEMS & Piezoelectric Devices, Microfluidics, Chemical Reaction Engineering, Materials, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization, Studies & Solvers Version 4.1 0 Replies
Please login with a confirmed email address before reporting spam
I don't know if someone has already asked this question but I couldn't find an answer and would appreciate your help. I am simulating the response of a solid phase sensor. My geometry is a rectangle and the active element is one of the sides of the rectangle which is a boundary with weak PDE condition. I would like to integrate one of the dependent variables over this active element. I used integration coupling variables in comsol 3.5 version but i don't know what to do in 4.1 version. I already tried defining an integration from model couplings in definitions and then using the integration coupling to define a new variable but it's not working properly, the results don't make any sense.
Hello Sahar Monfared
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.