Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2d velocity input vs flow rate input various result

Posted 2011/09/15 21:22 GMT-4 0 Replies

Chang Rong
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello ,

i am a biginner of comsol and i am doing 2d modeling to simulate tiny tube with 0.6mm diameter , moreover, three holes size 50micronmeters in series, when the inlet was set as velocity m/s and transmit the velocity into flow rate m^3/s as the same amount, the outlet shows quite huge differnet value when sloved. Does anyone can help me to clarify what happend here.

PS, i am just start to using comsol and i am confused by weak function in comsol and how to set up the boundary condition as well.

Thank you,

have a good day , guys

Eric

0 Replies Last Post 2011/09/15 21:22 GMT-4
COMSOL Moderator

Hello Chang Rong

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content