Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Failed to find consistent initial values.
Posted 2011/12/17 2:43 GMT-5 Version 4.0, Version 4.2 2 Replies
Please login with a confirmed email address before reporting spam
Hi ,All
I tried used microwave heating, but error is:
Failed to find consistent initial values.
Singular matrix
There are 1 void equations (empty rows in matrix) for the variable mod1.mh.S1x
at coordinates: (0,0,0), ...
and similarly for the degrees of freedom (empty columns in matrix)
What is it meaning?
What can I do?
Thank you !
I tried used microwave heating, but error is:
Failed to find consistent initial values.
Singular matrix
There are 1 void equations (empty rows in matrix) for the variable mod1.mh.S1x
at coordinates: (0,0,0), ...
and similarly for the degrees of freedom (empty columns in matrix)
What is it meaning?
What can I do?
Thank you !
2 Replies Last Post 2011/12/20 16:29 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
Singular matrix mostly indicates that you have not defined enough BC conditions, or some a linearly linked such that there is no UNIQUE solution, and when you have several possible solution you need a human to select, the mathematical equations cannot be solved like that. So my word, go over the model again, check all material propertirs, BC's PER physics and count the number of dependnet variables and the number of boundary conditions, areyou sure all solutions are unique ?
--
Good luck
Ivar
Singular matrix mostly indicates that you have not defined enough BC conditions, or some a linearly linked such that there is no UNIQUE solution, and when you have several possible solution you need a human to select, the mathematical equations cannot be solved like that. So my word, go over the model again, check all material propertirs, BC's PER physics and count the number of dependnet variables and the number of boundary conditions, areyou sure all solutions are unique ?
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Check the default units in your geometry setup. If they are not meters, I have seen odd behavior like this since some values might not be converted correctly.