Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Manual Scaling

Posted 2012/02/06 8:37 GMT-5 2 Replies

captainmariah
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

How do I activate the manual scaling for PML in the RF-module?
When I right click its not listed in the add-list for PML.
2 Replies Last Post 2012/05/03 3:21 GMT-4
Jim Freels mechanical side of nuclear engineering, multiphysics analysis, COMSOL specialist
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012/02/06 21:31 GMT-5
All modules are scaled in the dependent variables portion of the model tree. There is a parent scaling for all variables, and an individual scaling for each variable.
All modules are scaled in the dependent variables portion of the model tree. There is a parent scaling for all variables, and an individual scaling for each variable.
Evgeni Sergeev
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012/05/03 3:21 GMT-4
Just to add for anyone who's searching, that the "Dependent Variables" node is found under the e.g. "Solver 1" node, under "Solver Configurations", under "Study 1".
Just to add for anyone who's searching, that the "Dependent Variables" node is found under the e.g. "Solver 1" node, under "Solver Configurations", under "Study 1".

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content