Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Arc lengths

Posted 2021/06/14 6:03 GMT-4 Simulation Apps 1 Reply

Kieran Holmes-Martin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am fairly new to COMSOL and I am trying to create a design in COMSOL model builder.

I am in the 2D model builder and I am trying to create an arc length of 40mm, but alter the radius of it.

Can anyone point me in the right direction?

Thanks

1 Reply Last Post 2021/06/14 9:13 GMT-4
Mark Harradine
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2021/06/14 9:13 GMT-4
Updated: 4 years ago 2021/06/14 9:13 GMT-4

create 3 global parameters:

Angle equal to 360 x ArcLength/(2 x pi x r)

ArcLength equal to 40[mm]

r equal to 30[mm] (for starters)

Create an circular arc in the Geometry node by specifying centre, radius and angles

have centre at 0,0

radius set to r

start and end angles set to -Angle/2 to Angle/2

job done!

create 3 global parameters: Angle equal to 360 x ArcLength/(2 x pi x r) ArcLength equal to 40[mm] r equal to 30[mm] (for starters) Create an circular arc in the Geometry node by specifying centre, radius and angles have centre at 0,0 radius set to r start and end angles set to -Angle/2 to Angle/2 job done!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content