Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

parametrize geometric quantities like element size

Posted 2022/07/12 11:19 GMT-4 2 Replies

Carl Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Is there any way of parametrizing geometric quantities like element size? Without it, one can only set 1 element size at a time and run comsol over and over, if there are many element sizes to test.

2 Replies Last Post 2022/07/13 4:21 GMT-4
Robert Koslover Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago 2022/07/12 23:27 GMT-4

You can use expressions in your size specifications for meshes. Your expressions can include parameters. Use a user-defined mesh and set the various expressions in them for various domains, surfaces, edges, etc.

-------------------
Scientific Applications & Research Associates (SARA) Inc.
www.comsol.com/partners-consultants/certified-consultants/sara
You can use expressions in your size specifications for meshes. Your expressions can include parameters. Use a *user-defined mesh* and set the various expressions in them for various domains, surfaces, edges, etc.
Carl Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago 2022/07/13 4:21 GMT-4
Updated: 2 years ago 2022/07/13 8:46 GMT-4

Thank you so much.

Thank you so much.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content