Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Criteria for Extracting a 2D Slice Data from a 3D model

Posted 2012/08/29 13:28 GMT-4 Geometry, Parameters, Variables, & Functions, Results & Visualization Version 4.0, Version 4.0a, Version 4.1, Version 4.2, Version 4.2a, Version 4.3 1 Reply

Michael Marana
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

What is COMSOL's criteria when I extract slice data from a 3D gridded model? Is it simply finding the nearest node points? If so, is it only including node points immediately adjacent to the slice plane, or is there a tolerance where a node point has to be within a certain distance of the slice plane?
1 Reply Last Post 2012/08/29 21:01 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012/08/29 21:01 GMT-4
Hi
check the node settings, it uses interpolation from closest elements, you can play with eome of theparameters such as polynomial order etc, check the doc

--
Good luck
Ivar
Hi check the node settings, it uses interpolation from closest elements, you can play with eome of theparameters such as polynomial order etc, check the doc -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content