Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Shape of sessile drop

Posted 2012/10/24 14:03 GMT-4 0 Replies

Prashant Agrawal
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am trying to model the equilibrium shape of a sessile water drop in comsol. I have used a 2D axisymmetric laminar two phase, phase field model for the same. I started off with the shape of drop as a quarter circle in the model. I ran the model for 0.3 seconds, and the movement of the interface was fine till around 0.1 seconds. But once the contact angle reached the given value, the size of the drop started decreasing and by the end it vanished completely.

Can someone please help me out with this?

Thanks and Regards,
Prashant
0 Replies Last Post 2012/10/24 14:03 GMT-4
COMSOL Moderator

Hello Prashant Agrawal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content