Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how mark a line/point/surface in an animation/figure

Posted 2024/03/17 23:27 GMT-4 2 Replies

Carl Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

How to keep track of and mark a line/point/surface with known x,y,z as red in an animation/figure under results to manifest that line/point/surface?

2 Replies Last Post 2024/03/26 1:23 GMT-4
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 2 years ago 2024/03/20 9:01 GMT-4

If you want to trace a point at a certain location, use a Point Trajectories plot.

If you want to track a certain Point/Line/Surface, add a plot of the same type, set the color to Uniform Red, and add a Selection containing only the intended object. You can then add a Deformation node to make it follow the structural displacements.

-------------------
Henrik Sönnerlind
COMSOL
If you want to trace a point at a certain location, use a *Point Trajectories* plot. If you want to track a certain Point/Line/Surface, add a plot of the same type, set the color to *Uniform* *Red*, and add a *Selection* containing only the intended object. You can then add a *Deformation* node to make it follow the structural displacements.
Carl Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago 2024/03/26 1:23 GMT-4

thank you very much Dr Sönnerlind

thank you very much Dr Sönnerlind

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content