Unwanted diffusion of level set interface

Please login with a confirmed email address before reporting spam

Hi

I have been trying to model the droplet formation through an orifice using the level set method. I have been using the reinitialization value as the maximum speed of the droplet and default interface thickness. I have used extremely fine meshing and added 2 times refinement to the domain making the mesh very small. But still the interface is diffused and the droplet interface is not properly captured.

Currently the interface thickness is coming around 10-20 times greater than the mesh size. Manually giving the interface thickness is leading to some artifacts while solving and sharp edges in the final result.

I have attached the screen shots of the mesh and the diffused interface along with the question.

Kindly suggest some solutions for the same.



0 Replies Last Post 2025/04/28 17:22 JST
COMSOL Moderator

Hello Antony Xavier

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.