Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Lumped port question

Posted 2025/06/05 9:32 GMT-4 Electromagnetics, Modeling Tools & Definitions 0 Replies

Kyle MacRobbie
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am trying to model a simple 3D wire with MHz AC current running through it using the magnetic fields interface with lumped ports.

I am printing out the parameters that the solution gives me for the lumped port, and I am a bit confused as to how to interpret them. I get an impedance, is this the impedance of just the region of the lumped port itself, or everything that is attached to the lumped port. Same for the power and voltage, is this for the whole system or only the lumped port itself?

Thanks

0 Replies Last Post 2025/06/05 9:32 GMT-4
COMSOL Moderator

Hello Kyle MacRobbie

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content