Two sided Wall (line) boundary conditions - Form Assembly

Please login with a confirmed email address before reporting spam

Hello, when there is a line which is wall in form assembly, so, there is 2 sides of this wall. Can I use different boundary conditions in this situation? As example: one side is No Slip and the other Slip condition?

I make a simple test and When I did this, It was give different velocities when I compare the side of Slip condition. So, when I use the 2 sides as Slip it give me correct solution. When I use No slip in one side and Slip in another, the Slip condition is giving different value compared the prior test.


Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.