Eddy Simulation as Inspection

Please login with a confirmed email address before reporting spam

Hi, I'm a doctoral student using the License number COMSOL® 6.3, in my thesis. So, my objective is to simulate an eddy current inspection for a heat exchanger tube. You can understand this kind of test by watching the video on the YouTube link (https://youtu.be/MYd92lzhsX8?si=mtOjR_rgwhkP2LJP). How can I assemble this kind of model in COMSOL? Could you please help me? Basically, I need to insert a bobbin coil sensor probe inside a tube, where the probe should be moving inside the tube along time. In the end, I want to see the impedance plan for each step, XL versus XR, and all steps as voltage versus amplitude versus probe displacement. Please, I need your help!!!


0 Replies Last Post 2025/07/07 9:26 JST
COMSOL Moderator

Hello Romulo Almeida

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.