Magnet Modeling Assistance

Please login with a confirmed email address before reporting spam

Hey y'all,

I am trying to create a simulation measuring the torques of cubic magnets in an external field, very similarly to the "Force Calculation 3 — Magnetic Torque BEM FEM" COMSOL guide. However, COMSOL uses a series of pre-defined variables in this guide, which I am not sure can be applied to mine. I have attached below my file, and am wondering 1) whether the same variables can be used (accounting for differences in surface area etc.), and 2) if not, how should I go about simulating these torques? Additionally, COMSOL does not define any specific materials in the guide, just a blank with a permeability of 1. Am I able to specify a neodymium material for the magnets or do I have to go that route? Thanks in advance!



0 Replies Last Post 2026/01/16 20:53 GMT-5
COMSOL Moderator

Hello Emmett Freeman

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.