Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modeling phase change

Posted 2013/10/04 11:15 GMT-4 Fluid & Heat, Heat Transfer & Phase Change Version 3.5a 0 Replies

Vivek Pandey
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I need to model heat transfer in a cubical container that contains a phase change material (like water). A refrigerant fluid flows through the tubes inside the container at a temperature lower than the freezing point of the phase change material.

How should I proceed?
0 Replies Last Post 2013/10/04 11:15 GMT-4
COMSOL Moderator

Hello Vivek Pandey

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content