Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Microwave heating port phase question

Posted 2013/10/06 2:31 GMT-4 RF & Microwave Engineering, Heat Transfer & Phase Change Version 4.0 0 Replies

Harvey Kurniawan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone,

How can someone use the port phase field in microwave heating? At first I tried to enter "3.14/2" to get pi/2 condition but the "comsol failed to find consistent initial values" error came out. After that I try to enter some random numbers but that error keeps surfacing. Can somebody please help me? I try to simulate a microwave oven with 2 waveguide that has different phase.

Thank you very much.

Best regards,


Harvey
0 Replies Last Post 2013/10/06 2:31 GMT-4
COMSOL Moderator

Hello Harvey Kurniawan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content