Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problems meshing an example

Please login with a confirmed email address before reporting spam

I am following the Eddy Currents in 3D example in AC/DC module. In particular, I am interested in the reduced form (using a specified magnetic vector potential) to solve the problem. The external magnetic vector potential is used as an expression, generated by a current carrying wire.

I am getting a meshing problem when I try to mesh the infinite domain shell. I try to sweep mesh parameters manually with 3 elements, and get an invalid topology error message.

I am attaching the model to this post, so maybe someone can take a look and tell me where I am going wrong ?

Thanks.

PS : The dimensions are a little different, but I have followed the same steps.
PPS : I did not use cutting planes to section off the shell as I did not understand why that was necessary.


0 Replies Last Post 2009/09/07 2:55 GMT-4
COMSOL Moderator

Hello M Singh

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.