Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
changing boundry condition by loop
Posted 2010/07/27 8:40 GMT-4 0 Replies
Please login with a confirmed email address before reporting spam
I have a case of rectangular duct where i want to put the results from exit to the inlet of rectangular duct and i want to do it continuously for many 100 times.
It is a means to reduce meshing by simulating the small part of rectangular duct by looping.
can somebody help me to know if this is really possible in COMSOL.
Regards and Thanks
Chattarbir Singh
Hello chattarbir singh
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.