アプリケーションギャラリ

Solar concentrator/cavity receiver systems can be used to focus incident solar radiation into a small region, generating intense heat which can then be converted to electrical or chemical energy. A common figure of merit in solar thermal power systems is the concentration ratio, or the ... 詳細を見る

This app demonstrates the following: Multiple components (1D and 3D) in a single app Using the same choice list in the app as in the model using Data Access functionality Output numerical results for a specific time step using a combo box The app combines the Ray Optics Module and ... 詳細を見る

This model exemplifies the analysis of strong wind flow around a solar panel and the corresponding structural displacement due to the wind's load. The solar panel is located in an array of equally spaced identical panels, which allows for the assumption that the periodic flow conditions ... 詳細を見る

A paraboloidal dish can concentrate solar energy onto a target (receiver), resulting in very high local heat fluxes. This can be used to generate steam, which can be used to power a generator, or hydrogen, which can be used directly as a fuel source. In this model, the heat flux arriving ... 詳細を見る

This tutorial uses a simple 1D model of a silicon solar cell to illustrate the basic steps to set up and perform a device physics simulation with the Semiconductor Module. A user-defined expression is used for the photo-generation rate and the result shows typical I-V and P-V curves of ... 詳細を見る

This example shows an approximate approach to model a dot-in-well solar cell as described by Asahi et al. in the reference paper. The quantum wells and the layers of quantum dots are each treated as lumped energy levels in the band gap. The authors specify transitions between the dot ... 詳細を見る

This model demonstrates how to compute satellite temperature over multiple orbit periods by coupling Orbital Thermal Loads to Heat Transfer in Solids. The direct solar, albedo, and Earth infrared thermal loads are computed over a single orbit, and are periodically repeated over multiple ... 詳細を見る

蓄熱ユニットは, 太陽熱, 地熱, または廃熱源からの熱エネルギーを蓄積するために使用されます. 最もシンプルなユニットは, 家庭でよく見られる水タンクで構成され, 太陽エネルギーを検知可能熱として蓄えます. これらのタンクの熱容量は潜熱を蓄えることでさらに増加し, 潜熱蓄熱（LHS）ユニットとして利用されます. 通常, LHSタンクには, 相変化物質としてパラフィンが充填された球状カプセルが内蔵されています. この例では, 充填ベッド蓄熱タンク内の流れをモデル化し, 相変化を伴う熱伝達とLHSユニットへの充填時の局所的な熱非平衡の影響を考慮しています. 詳細を見る

This model illustrates an application that maximizes surface-to-surface radiative fluxes and minimizes conductive heat fluxes. A thermo-photo-voltaic (TPV) cell generates electricity from the combustion of fuel and through radiation. The fuel burns inside an emitting device that ... 詳細を見る

This model is an introduction to defining and verifying a satellite orbit, and computing the solar, albedo, and Earth infrared thermal loads. A 1U CubeSat is in a circular orbit at 400km altitude, inclination of 50°, and longitude of ascending node of 0°. The satellite is rotating slowly ... 詳細を見る