アプリケーションギャラリには電気, 構造, 音響, 流体, 熱および化学分野に関連する COMSOL Multiphysics® チュートリアルおよびデモアプリファイルが用意されています. これらの例はチュートリアルモデルまたはデモアプリファイルとそれに付随する手順をダウンロードすることにより独自のシミュレーション作業の開始点として使用できます.
クイック検索機能を使用して専門分野に関連するチュートリアルやアプリを検索します. MPHファイルをダウンロードするには, ログインするか, 有効な COMSOL ライセンスに関連付けられている COMSOL Access アカウントを作成します. ここで取り上げた例の多くは COMSOL Multiphysics® ソフトウェアに組み込まれ ファイルメニューから利用できるアプリケーションライブラリからもアクセスできることに注意してください.
This example simulates 3D unsteady laminar flow past a cylinder in a channel. The inflow velocity profile is time-varying. The lift and drag coefficients are computed, and results show good agreement with those published in the literature. 詳細を見る
This model simulates a temperature profile in a number of cells and cooling fins in a liquid-cooled battery pack. The model solves in 3D and for an operational point during a load cycle. A full 1D electrochemical model for the lithium battery calculates the average heat source. 詳細を見る
次のモデルは, 流れてくる流体に対して直角に流路内に置かれた長い円筒を過ぎる非定常で非圧縮性の流れを調べます. 円筒は流れの中心からいくらかオフセットされており, 定常状態の対称的な流れを不安定にします. 周期的な流れのパターンが現れるのに必要なシミュレーション時間は予測が困難です. 重要な予測因子は, 円筒の直径に基づくレイノルズ数です. 値が 100 未満の低い場合, 流れは定常です. このシミュレーションでは, レイノルズ数は 100 に等しく, 発達したカルマン渦列が生じますが, 流れはまだ完全に乱流ではありません. 詳細を見る
Chemical engineering students can model a nonideal tubular reactor, including radial and axial variations in temperature and composition, and investigate the impact of different operating conditions with this easy-to-use app. The process described by the Tubular Reactor with ... 詳細を見る
Light pipes are structures that can be used to transport light between different locations. In general, they can be divided into two major groups: tubes lined with a reflective coating and transparent solids that contain light via total internal reflection. In this tutorial, light is ... 詳細を見る
This model defines a zero-gap alkaline water electrolyzer, where oxygen and hydrogen gas are evolved in porous gas diffusion nickel felt electrodes, placed adjacent to a porous separator (diaphragm). The geometry defines a unit cell of an electrolyzer stack, in turn comprising two full ... 詳細を見る
流体が材料やエネルギーの輸送に使用される場合, 流動する流体の速度を知ることは重要です. 流速を測定する飛行時間法または通過時間法では, 超音波信号をパイプ内の主流に伝達して, 非侵襲的に流速を測定します. 主流に対して角度を付けて信号を送信することにより, 超音波信号は主流の方向に移動する場合は音速よりも速く伝わり, 主流に逆らって移動する場合は音速よりも遅く伝わります. 2 つの方向の移動時間の差は, 主流の速度に比例して増加します. このタイプの流量計は, 特に産業環境で多くの用途があります. このチュートリアルモデルでは, COMSOL ... 詳細を見る
Interfacial failure or delamination in a composite material can be simulated with a cohesive zone model (CZM). A key ingredient of a cohesive zone model is a traction-separation law that describes the softening in the cohesive zone near the delamination tip. This example shows the ... 詳細を見る
このチュートリアルでは, パラメーター推定機能を用いて MEMS 共振器の電気回路モデルを導出する方法を説明します. このモデルは, 電気回路インターフェースを用いて作成された修正 Butterworth-Van Dyke 回路であり, 薄膜バルク音響共振器 (FBAR) を表しています. パラメーター推定スタディを用いて, モデル内の集中定数素子のパラメーターを解析しました. 詳細を見る
Dielectric microspheres can support whispering gallery modes with high optical quality factors. This model illustrates how to compute the different eigenmodes and resonance frequencies. The resonance frequencies are either filtered by their spatial localization in the resonator or by ... 詳細を見る
