アプリケーションギャラリ

This model computes the fundamental eigenfrequency and eigenmode for a tuning fork that is synchronized from Pro/ENGINEER via the LiveLink interface. The length of the fork is then optimized so that the tuning fork sounds the note A, 440 Hz. 詳細を見る

A demultiplexer is a device that directs different frequency bands to different outputs. In this tutorial model, we will design a demultiplexer by performing shape optimization on all initial circular boundaries in a sonic crystal (phononic crystal) configuration. The model uses shape ... 詳細を見る

This model is used to demonstrate the solution to a classic brainteaser in electromagnetics. A long loop of wire is connected to a source and a receiver, which are placed 1 meter apart. The objective of the model is to compute how long it takes for the receiver to sense when the source ... 詳細を見る

In food industries, microwave heating is gaining attention over a conventional heating treatment because of several advantages such as precise process control, speed of heating, fast turn-on and turn-off time, etc. In this model, a high directional Yagi-Uda antenna is used to heat up ... 詳細を見る

Cryer's problem is a three-dimensional consolidation benchmark. A porous sphere is subjected to a uniform boundary pressure. The pore pressure at the center of the sphere rises due to the Mandel-Cryer effect that is captured by a two-way coupling between Darcy's law and solid mechanics. 詳細を見る

You can use the Method Editor in the Application Builder for creating methods that perform almost any type of modeling tasks, including geometry modeling. It is easy to miss the fact that methods can support recursion by having a method calling itself in a recursive loop. Here, we will ... 詳細を見る

This model presents a way to compute projected area using the Surface-to-Surface Radiation interface of the Heat Transfer Module. By computing illuminated area from a set of directions on a discretized sphere, it is possible to interpolate the projected area onto any angle of incidence. ... 詳細を見る

A waveguide filter is designed using shape optimization by moving and scaling rectangles in the geometry. The irises of the initial geometry are optimized to ensure good bandpass response and out-of-band rejection, while maintaining the double mirror symmetry. The EGO optimization solver ... 詳細を見る

This model computes the specific acoustic radiation impedance of a very small circular vent in a flanged configuration. The model includes thermoviscous losses. The radiation impedance is fitted using a simple RL circuit which gives a simple lumped representation. The results are used ... 詳細を見る

This example shows how to model the behavior of a thermostat where a delay in its reaction has been implemented. A more detailed description of the phenomenon, and the modeling process, can be seen in the blog post "How to Implement a Delay in Your Thermostat Simulation". 詳細を見る