アプリケーションギャラリ

This model illustrates the use of COMSOL Multiphysics for modeling of ionic current distribution problems in electrolytes, in this case in human tissue. The problem is exemplified on a pacemaker electrode, but it can be applied in electrochemical cells like fuel cells, batteries, ... 詳細を見る

This example uses the Shallow Water equations to model the impact of a water wave on a column. A body of water with a height of 0.3 meters is initially contained behind a gate. At the start of the simulation, the gate is suddenly released and the body of water forms a wave moving toward ... 詳細を見る

このモデルは, COMSOL Multiphysics で流体構造相互作用問題を設定する方法を示しています. 流体の流れが固体構造をどのように変形するか, また連続的に変形するジオメトリで流れを解く方法を示しています. 流体構造相互作用 (FSI) マルチフィジックスインターフェースは, 流体の流れと固体力学を組み合わせて, 流体と固体構造の相互作用を捉えます. 固体力学インターフェースと単相流インターフェースは, それぞれ固体と流体をモデル化します. FSI カップリングは, 流体と固体の境界に表示されます. 流体構造相互作用インターフェースは, ... 詳細を見る

アルカリ水電解は, 水素ガスを生成するための確立された工業プロセスです. セル内では, 陰極で水素ガスが, 陽極で酸素ガスが生成されます. 電解液は水溶液であり, 発生したガスが泡状になると, 実効イオン伝導率が低下します. また, 発生したガスは, 電極反応がアクセス可能な表面積を減少させることから, セルの性能に悪影響を及ぼす可能性があります. この例では, ガス生成がアルカリ電解セルの性能に与える影響を調査します. 詳細を見る

A conductive diaphragm, an iris, placed transverse to a waveguide aperture causes a discontinuity and generates shunt reactance. Bandpass frequency response can be achieved from cascaded cavity resonators combined with these reactive elements which can be created by inserting a series of ... 詳細を見る

Continuous mixing is used in process equipment to mix components in a single pass. Compared to batch mixing, this operation has the advantage that the tank filling and emptying steps are eliminated, implying that the process can be run without interruptions. A disadvantage of continuous ... 詳細を見る

It is often not possible to insert a normal microphone directly into the sound field being measured. The microphone may be too big to fit inside the measured system, such as for in-the-ear measurements for hearing aid fitting. The size of the microphone may also be too large compared to ... 詳細を見る

This example treats the modeling of sub-surface flow where free convection in porous media is analyzed. The results are compared with published literature in the field. The model couples the momentum balance to an energy balance through an equation, dependent on temperature, being ... 詳細を見る

In this example, a dynamic analysis of a three-cylinder reciprocating engine is performed to investigate stresses generated during operation, thereby permitting identification of the critical components. Demand for high power output relative to the weight of the engine requires careful ... 詳細を見る

Prior to the reliability testing, surface-mount devices (SMDs) are required to go through a preconditioning process, which represents the effects of storage and the typical reflow operation in the following board assembly process. During the preconditioning process, test samples usually ... 詳細を見る