アプリケーションギャラリ

この例では, 水で満たされた貯水池の上に置かれた細い垂直シリンダーを調べます. 空気と水の界面の壁面接着と表面張力により, 水は流路を通って上昇します. 表面張力と壁面接着力は, MEMS デバイスのマイクロ流路を通じて流体を輸送したり, マイクロピペットを使用して少量の流体を測定, 輸送, 配置したりするためによく使用されます. 多孔質媒体を通る多相流や固体壁上の液滴も, 壁面接着力と表面張力が流れのダイナミクスに強く影響する例です. 壁面の接着力を正しくモデル化するには, 境界条件の扱いが重要です. 壁面の速度をゼロに固定すると, ... 詳細を見る

This model simulates a simple three-dimensional axisymmetric Helmholtz resonator, a classic acoustics model of a resonating circuit with a known theoretical solution. The idealized version considered here consists of a tube and a closed volume in series which are exposed to a pulsatile ... 詳細を見る

This example demonstrates how to model moisture transfer and induced swelling in a paperboard roll subject to varying ambient conditions. The material properties of the paperboard are anisotropic. 詳細を見る

This tutorial introduces the use of topology optimization in acoustics. The goal of the optimization is to find the optimal material distribution (solid or air) in a given design domain, here the ceiling of a 2D room, that minimizes the average sound pressure level in an objective ... 詳細を見る

Different types of elements can be used for modeling a rotor, depending on the level of complexity and the type of the system being modeled. The modeling steps and representation of the results will vary with the type of idealization. In this tutorial model, an eigenfrequency analysis is ... 詳細を見る

The stresses in a pulley connected to an engine that drives another pulley are studied in this model. A parametric analysis is conducted in order to study how the rotational speed affects the stress distribution in the pulley. The power at the pulley shaft remains constant, the moment ... 詳細を見る

This benchmark model computes the transient pressure distribution and film height in a squeeze film bearing for lubrication in a nonconformal conjunction of a solid sphere and an elastic wall separated by a lubricant film. This model solves the benchmark case of hydrodynamic interaction ... 詳細を見る

This example is an extension of a model used to study the vibration and noise in a 5-speed synchromesh gearbox in a manual transmission vehicle. In this version of the model, a detailed representation of a roller bearing is used instead of hinge joints with elastic stiffness. First, the ... 詳細を見る

A benchmark model of the Rainflow counting algorithm compares results between ASTM and COMSOL fatigue module using a flat tensile test specimen. An extension is made for the cumulative damage calculation following the Palmgren-Miner model and results are compared with analytical ... 詳細を見る

A standing contact fatigue test is a procedure used for testing crack growth on the subsurface level. In such a test, a spherical object is pressed against the tested materials and cycled between a high and low compressive load. No translational movement between the two occurs. After a ... 詳細を見る