アプリケーションギャラリ

The dielectric shielding boundary condition is meant to approximate a thin layer of material with high relative permittivity compared to its surroundings. This boundary condition is available for electrostatic field modeling. This example compares the dielectric shielding boundary ... 詳細を見る

This tutorial model presents a study showing the transient negative mobility and the negative differential conductivity effects in xenon. The stationary and time dependent Boltzmann equation in the two-term approximation is used to compute the electron energy distribution function. ... 詳細を見る

This example models galvanic corrosion between two different phases in a magnesium alloy for a representative cross-sectional microstructure configuration. The Level Set interface is used here to model dissolution of a constituent phase leading to topological changes. The electrode ... 詳細を見る

This small tutorial model shows how to set up a model with a solid mechanics and a pressure acoustics domain including a common perfectly matched layer (PML). The PML is used to model an open or infinite domain for both the elastic waves and the pressure waves. Three configurations of ... 詳細を見る

This model exemplifies how the rate of steel corrosion in an oil platform increases over time due to build-up of a resistive film on the sacrificial anodes, formed by reaction products. The model also includes secondary current distribution electrode kinetics on the protected steel ... 詳細を見る

This tutorial demonstrates how to integrate multiple Lumped Battery models into the Electrical Circuit interface. Two batteries are connected in series. Each battery is protected by a shunt resistances that is activated if the battery state-of-charge reaches below a certain threshold ... 詳細を見る

流体ダンパーは, 軍事機器における衝撃吸収, 土木構造物における地震や風による振動の抑制など, 様々な用途に使用されています. 流体ダンパーは, 機械エネルギーを熱に変換することで機能します. このモデルは, 流体ダンパーにおける粘性加熱とそれに伴う温度上昇の現象を示します. 粘性加熱はマイクロ流体デバイスにおいても重要です. マイクロ流体デバイスでは, 断面積が小さく長さが長いため, 大きな発熱が発生し, 結果として流体の流れに影響を与える可能性があります. このモデルでは, 共役熱伝達, 層流, 移動メッシュの各インターフェースを用いて時間依存スタディを実施します. 詳細を見る

These models demonstrate the usage of the user defined lumped port and lumped elements to introduce excitations and lumped circuit elements between volumetric conductors. Additional models show how to use impedance and transition boundary conditions to model the conductors, instead of ... 詳細を見る

This example simulates particles in a range of sizes that move through different levels of a cascade impactor. A cascade impactor is an inertial particle separation device consisting of multiple levels separated by collecting plates and nozzles. Particle-laden air enters from the top ... 詳細を見る

In this model, we introduce a cloaking method using an electrically tuned monolayer of graphene. We will show that when a cylindrical dielectric scatterer is covered in graphene, the scattering cross section is greatly reduced at the designated frequency, making it electromagnetically ... 詳細を見る