研究開発におけるマルチフィジックスシミュレーションの具体例
さまざまな業界のエンジニア, 研究者, 科学者がマルチフィジックスシミュレーションを使用して革新的な製品の設計とプロセスを研究および開発しています. COMSOL カンファレンスで発表したテクニカルペーパーやプレゼンテーションからインスピレーションを得てください. 以下の選択項目を参照するか, クイック検索ツールを使用して特定のプレゼンテーションを検索するか, アプリケーション領域でフィルタリングします.
COMSOL コンファレンス 2020 論文集を見る
Investigation on Quiet Zones Created by Remote Impedance Control
Quiet zones and other sound zones have been a strong topic of research for some time, due to the interest of creating separate sound environments in a same room, in a large open-space office for example. A number of solutions have been proposed over the last years. This paper further ... 詳細を見る
Modeling the Dynamic Viscous and Thermal Dissipation Mechanisms in a Fibrous Porous Material
The main mechanisms of acoustic attenuation in a bundle of fibres typical of lightweight fibrous porous materials are the dynamic viscous drag forces on the surface of the fibres, and the thermal heat transfer between the solid fibres and the surrounding fluid. Microstructure models ... 詳細を見る
Simulation of the Electrical Properties of Conductive ITO Thin Films by Finite Element Analysis
Finite element analysis (FEA) can be used to study the electrical properties of conductive ITO thin films. Previous studies have been done on insulating thin films deposited on conductive substrates [1,2]. It was found that changes of electrode size and film thicknesses can cause huge ... 詳細を見る
Seat Motor Design Optimization
In this work, the production intent design of a motor with controller inside a car seat for head restraint function is analyzed and optimized using the COMSOL Multiphysics® software and the Application Builder. Parameter based multiscale FEA models were developed by using external CAD ... 詳細を見る
On The Directional Response of Multi-Driver Column Loudspeaker Configurations Using FEA and BEM
Column Loudspeakers employ multiple drivers to get close to a radiating line source. A line source gives several acoustic advantages versus a point source, especially in highly reverberant environments. This property particularly has made column loudspeakers the preferred solution in ... 詳細を見る
Modeling, Simulation, and Optimization of Piezoelectric Bimorph Transducer for Broadband Vibration Energy Harvesting in Two-piece Trapezoidal Approach
The objective of the research is to design a broadband energy harvester device through the two-piece non-linear trapezoidal geometry approach. The performance of two piezoelectric PZT-PZN polycrystalline ceramic composition samples are simulated in the COMSOL Multiphysics® software, and ... 詳細を見る
Analysis of Mechanical Sensitivity of MEMS Pressure Diaphragm for Contact Formation
MEMS Pressure sensors work on the principle of mechanical bending of thin diaphragm under applied load over diaphragm area. The sensitivity of diaphragm is crucial to efficiency of the sensor. It is defined as the increase in deflection of diaphragm as a result of increase in pressure ... 詳細を見る
Vibration and Noise Analysis of the Feather River Bridge
The U.S. Army Engineer Research and Development Center (ERDC) is conducting research using infrasound arrays to detect and monitor structures as well as for dynamic structural characterization of large infrastructure. Previous studies have determined that structures radiate acoustic ... 詳細を見る
Resonance Frequency of a Helmholtz Resonator
Acoustic metamaterials commonly use Helmholtz resonators to attenuate an acoustic signal at the resonator’s resonance frequency. The resonance frequency is only dependent on the geometry, which is shown by representing the Helmholtz resonator as a mass spring system using the lumped ... 詳細を見る
Load Noise Calculation of a Three-Phase Power Transformer
Vibrations and noise of high power transformers have attracted considerable experimental and theoretical interests over last few years [1, 2]. For such transformers operating under high voltage (~ 100 kV) and power (~ 100 MVA), noise generated is significantly attributed to load noise ... 詳細を見る