技術情報とプレゼンテーション

The development and analysis of interconnects in inhomogeneous structures such as very large scale integration chips, printed circuit boards, and multichip modules are essential for next-generation electronic products. In this paper, we illustrate fast and sufficiently accurate ... 詳細を見る

In spite of its low throughput, Patch-Clamp is the established method for intracellular measurements of the transmembrane potential. To address this problem, we have developed new biosensor-chips with micro-structured needle electrodes (MNEs). MNE-penetration of single cells growing on ... 詳細を見る

In our project, we propose an innovative software solution to the problem of electrical arcing risk prediction in high-voltage on-board electronic equipment intended for long-term self-contained use, e.g. in spacecraft conditions. It completely based on so-called “decomposition” approach ... 詳細を見る

The recently developed technique Scanning Tunneling Microscopy in the Field Emission regime (STM FE) is based on the Russell Young's topografiner technology. The set-up is a no contacting device consisting of a sharp tip approached vertically to a conducting surface at variable distances ... 詳細を見る

Magnetic levitation systems have been studied in the context of high-speed transportation as maglev trains, high speed machinery as magnetic bearings, and other similar engineering applications. In this paper, a three dimensional arbitrary shaped object is modeled and analyzed through ... 詳細を見る

Prototype Fast Breeder Reactor (PFBR) has two independent, diverse, fast acting & fail safe shut down systems to achieve the required level of safety & reliability (1). The shut down systems comprises of nine numbers of Control & Safety Rod Drive Mechanisms (CSRDM) & ... 詳細を見る

This paper describes a type of didactic material used when teaching electromagnetism. The purpose is to guide the students to verify the results of a Finite Element (FE) simulation using those obtained analytically. This procedure has shown to be of great help during their learning of ... 詳細を見る

MEMS resonators have been recently adopted in a wide variety of timing, sensing, and actuation applications. The ability to control the dynamics of resonance, namely the resonance frequency and quality factor of these resonators is crucial in achieving high precision performance within ... 詳細を見る

Due to the complexity of electromagnetic modeling, researchers and scientists always look for development of accurate and fast methods to extract the parameters of electronic interconnects and package structures. In this paper, we illustrate modeling of multiconductor interconnects in ... 詳細を見る

This article describes the development of a bulk mode resonator which can be employed for detection of bio/chemical species in liquids.  The goal is to understand the mechanical and electrical properties of a bulk mode resonator device which exhibit high frequency resonance modes and Q ... 詳細を見る