技術情報とプレゼンテーション

Surface acoustic wave (SAW) devices are widely used for their sensing capabilities and gas sensing is only one of many uses. There is an ever increasing need to make them as effective as possible by adding nanomaterials to the device. In this study a two-port delay-line structure with ... 詳細を見る

After rapid mixing of waste water and coagulant, an effective slow mixing during a reasonable retention time will cause to grow the size of flocs up which will settle out easily. Around-the-end hydraulic mixer with barriers is one of the efficient facilities that have been used in water ... 詳細を見る

This paper presents steady and unsteady computational results obtained from numerical solutions of the full two-dimensional governing equations for annular internal condensing flows in a channel. This is achieved by tracking the “sharp” interface while solving the flow fields using ... 詳細を見る

This paper describes how to numerically tackle the problem of counting and sizing particles by impedance measurement in an orifice–electrode system. The model simulate the particle dynamics submitted to strong hydrodynamic stresses through a microorifice and compute the voltage pulses ... 詳細を見る

Single coil actuators are representing one important component of ABB’s medium voltage reclosers. Their performance is strongly influenced by the considered material properties as well as by the electronic control units’ properties that will power the actuator. Therefore, this paper ... 詳細を見る

Fuel bundles in the CANDU (CANada Deuterium Uranium) reactor are designed for heating a pressurized coolant (heavy water) to generate electricity. The designs for the fuel bundles differ based on the number of heating elements. The flow of heavy water over the elements and inside the ... 詳細を見る

An alluvial aquifer system has probably conceived as a numerical modeling hell. We have chosen COMSOL Multiphysics® for two reasons: 1) FEM methods allow to use complex geometries; 2) multiphysics simulation permits to run a single model with all phenomena. We built a section with these ... 詳細を見る

Noninvasive radiofrequency (RF) tissue heating is frequently used for skin tightening and facial wrinkle reduction as alternative to invasive surgical procedures. However, to ensure a safe and efficient therapy, the temperature of the skin and the subcutaneous tissue must be controlled ... 詳細を見る

The optimisation of dimensions, materials choice of heaters in annealing furnaces are done with COMSOL Multiphysics® in 2D-axisymetry. Heat losses sources are identified and corrective actions can be taken in function of simulation results. A power saving of more than 50% is achieved ... 詳細を見る

Micro-tubular Solid Oxide Fuel Cells (mSOFC) are attracting more and more interest as new generation of energy conversion devices. Although commercial applications still suffer from high costs, there is a need for further improvement of the cell performance, durability and start-up. To ... 詳細を見る