技術情報とプレゼンテーション

The continuous and intensive use of squirrel-cage induction motors in the modern industry, has in some cases caused a serious deterioration of the electrical insulation in the windings of the machine, generating as a consequence internal short-circuit failures, the effects on the ... 詳細を見る

Plasma torches are used in processing of materials and in energy industry for producing plasma. In this work we use the Equilibrium DC Discharge physics interface of COMSOL Multiphysics® to model a DC non- transferred arc plasma torch, under hypothesis of local thermodynamic equilibrium. ... 詳細を見る

The finite element method applied to the k-epsilon turbulence model is used to investigate the two-stream turbulent mixing layer. Whereas the model is known as one of the most popular of the turbulence models to date, the model has yet to be applied to the classical mixing layer problem ... 詳細を見る

The structural design of temporary storage facilities for radioactive waste generally requires the fulfillment of highly severe performance criteria if compared to conventional buildings. This work focuses on the study of the behavior of a steel door subject to the impact of extreme wind ... 詳細を見る

The quality of coatings obtained by means of thermal spraying depends strongly on the mechanism of the interaction between the molten droplets and the surface to be covered. The aim of the present study is to simulate the impact of a droplet onto a substrate, in order to have a good ... 詳細を見る

Adaptive optics control using liquid filled membrane lens is based on the principle of deflection of polymeric membrane. Controlled deflection in membrane leads to controlled focal length. This enhances the focus tuning ability of the system at the same time make optical system compact ... 詳細を見る

Introduction Velocity profiles in liquid films flowing over rotating conical surfaces are of considerable interest in industry. The efficiency of important process equipment, such as spinning cone columns, fluid degassers, centrifugal disc atomizers, centrifugal film evaporators, and ... 詳細を見る

Laser welding is often considered to be a superior technique over different conventional welding methods and has been gradually evolved as an efficient manufacturing process. It is a high energy density fabrication process and generally employed for fabricating intricate shapes/contours ... 詳細を見る

Liquid transport in lab-on-a-chip (LOC) devices occurs through a microchannel that uses an electroosmotic flow actuation mechanism. This method has a plug-like velocity profile, which is ideal in species transport and in wall-bounded reactions. Under substantial joule heating, it is not ... 詳細を見る

In this work, we numerically investigated the process of droplet generation using water as the dispersed phase and FC-40 oil as the continuous phase in a microfluidic device. We used a two-phase level set method in COMSOL Multiphysics® for our study. The simulations were carried out in a ... 詳細を見る