技術情報とプレゼンテーション

In-situ electrical heating technologies are among the most recent technologies used for bitumen recovery from tar sand and oil shale. These technologies have limited environmental impact because there is little disturbance of the land, and water and solvents are not used. Two-phase ... 詳細を見る

When the dimensions of the material approach is a comparable size to the phonon mean free path, heat flow enters a new regime, the nanoscale. The Fourier and Cattaneo Equations describe bulk heat flow well, but radiative boundary terms must be considered when modeling nanoscale heat ... 詳細を見る

Finite elements using COMSOL Multiphysics have been used to simulate the edge plasma in a large area capacitively coupled RF reactor. In order to reduce numerical difficulties simplified reactor edge geometries have been used. First results show the importance of electrostatic double ... 詳細を見る

An optimal control problem (OCP) is studied to a PDE of elliptic type as well as state constraints. The resulting optimality system contains two PDEs, one algebraic equation and the so called complementary slackness conditions, i.e. dual products between function spaces. At this point, ... 詳細を見る

A site-binding/dissociation model is used to determine surface charge in numerical studies of the equilibrium potential and ion distributions inside infinite and finite-length nano-channels. This COMSOL model allows us to investigate the response of surface (zeta) potential to ... 詳細を見る

In the case of electron beam welding of copper with stainless steel, two principal cases of welding pool morphology are possible: a droplet-like microstructure where the electron beam deviates to the copper side due to the thermoelectric effect, so the volume of molten copper is much ... 詳細を見る

Benchmarks are an important tool to verify computational models. In the research area of building physics, the so-called HAMSTAD (Heat, Air and Moisture Standardization) project is a very well known benchmark for the testing of simulation tools. In this paper we evaluate the use of ... 詳細を見る

Murphy and Good general theory for electron emission from metal surfaces was used to predict the field-emission capabilities of ideal arrays of vertically aligned carbon nanotubes (VACNT). The Nottingham effect was taken into account in order to explain experimental observation of a ... 詳細を見る

This paper presents and discusses the first phase results of a wide ranging project concerning the study and prediction of the efficiency and energy performances of natural ventilation systems existing inside historic buildings. The air flow patterns, air temperature and air velocity ... 詳細を見る

Gas-liquid falling film microreactors carry out fast exothermic and mass transfer limited reactions. Since the major rate limiting steps occur on the liquid side, it is important to account for a realistic liquid film profile within the reactor simulation. Based on realistic channel ... 詳細を見る