技術情報とプレゼンテーション

This paper projects a novel 3D capacitive accelerometer design to identify a severe accident and initiate airbag deployment systems. It will detect the rapid negative acceleration of the vehicle to avoid the severity of the collision. Such a device demands excellent performance in terms ... 詳細を見る

A MEMS based Knudsen’s pressure gauge working in the range of 1e-5 mbar to 10 mbar is designed and simulated in COMSOL. The working principle is based on Knudsen’s forces that arise when two plates are held at different temperatures and their separation is comparable to the mean free ... 詳細を見る

This paper describes the use of COMSOL Multiphysics® during the design of a vented box loudspeaker. Templates have been created to model the different needs of a complete design. Based upon those templates a box has been prototyped, measured and confronted to simulation. The cabinet may ... 詳細を見る

Micro-tweezers have been widely investigated because of their extensive applications in micro-fluidics technology, microsurgery and tissue-engineering. It has been reported that thermal actuation provides greater forces and easier control when compared to electrostatic micro actuation. ... 詳細を見る

VRALA is the ideal candidate as an Adaptive Optics actuator at visible wavelengths. Its electric characteristics variations, suitable current commands, and an effective magnetic circuit geometry provide a 2 kHz correction bandwidth and a 25 mm actuator density. The magnetic core allows ... 詳細を見る

Over the past few decades, nano/micro-mechanical resonators have experienced tremendous improvements in measurement sensitivity. In order to ensure accuracy, it is crucial that each nano/micro-mechanical device is properly calibrated. Thermomechanical calibration provides a noninvasive ... 詳細を見る

Introduction: Vibration energy harvester can convert mechanical vibration energy into electrical energy and store it in battery for later use. It can create clean renewable energy from vibration movements such as walking, jumping, running, etc. This can convert energy previously wasted ... 詳細を見る

The main aim of the present work is the study of the thermal and energy performances of the new hall of the Old St.Maria Nuova Hospital in the center of Florence (Italy). Transient simulations were carried out of the 3D model of the hall to analyse the air flow patterns, distribution and ... 詳細を見る

This paper presents finite element method (FEM) simulation study of the generation of bulk acoustic waves (BAWs) and their effect on the performance of surface acoustic wave (SAW) devices, using COMSOL Multiphysics. A SAW delay line structure using YZ-cut lithium niobate substrate is ... 詳細を見る

Circuit board failures are often ignored because they could be impreceptible. This simulation examines how internal layers around a soldered pin via subject to temperature changes during the soldering process are affected, show the forces involved and determine breaking points. A 2D ... 詳細を見る