Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stress free boundary

Posted 2010/12/21 3:05 GMT-5 Structural Mechanics Version 3.5a 2 Replies

Chris McCorquodale
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

Is it possible to apply a stress free boundary to a model? For example, I have a model in which i am interested in the high stress region but because of the way my prescribed displacement constraints are applied the high stress region is in the wrong place. Is there any other way around this?

Thanks,

Chris
2 Replies Last Post 2010/12/21 6:57 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2010/12/21 3:53 GMT-5
Hi
Have you tried to define your fixed constraints such that you free the stress ?

i.e. instead of a "fixed constraint, use a roller on the boundary and fix a central point (or a few along different axis)

i.e. in thermal do not fix but impose a prescriped displacement depending on a material expansion coefficient and the temperature, providede you have a central CoG for thermal expansion

i.e use symmetry planes

there are many ways around to get an isostatic support without overconstraining, and still get easily representing displacement/stress values

Note: if you constrain a corner of a cube the displacement will go all in one direction, that is not always the easiest to debug/analyse, therefore try selecting a more central "fixed point"

Finally in V4.1 you might exclude your stress representation (or any plot representation) for some regions with a "filter" subnode and geometrical bolean operations

--
Good luck
Ivar
Hi Have you tried to define your fixed constraints such that you free the stress ? i.e. instead of a "fixed constraint, use a roller on the boundary and fix a central point (or a few along different axis) i.e. in thermal do not fix but impose a prescriped displacement depending on a material expansion coefficient and the temperature, providede you have a central CoG for thermal expansion i.e use symmetry planes there are many ways around to get an isostatic support without overconstraining, and still get easily representing displacement/stress values Note: if you constrain a corner of a cube the displacement will go all in one direction, that is not always the easiest to debug/analyse, therefore try selecting a more central "fixed point" Finally in V4.1 you might exclude your stress representation (or any plot representation) for some regions with a "filter" subnode and geometrical bolean operations -- Good luck Ivar
Chris McCorquodale
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2010/12/21 6:57 GMT-5
Hi Ivar,

Thanks for this, I'll try some of the things you have suggested!

Regards,

Chris
Hi Ivar, Thanks for this, I'll try some of the things you have suggested! Regards, Chris

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content