Menu

Discussion Forum

New Discussion
フィルター

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary Heat Flux

Posted 2012/08/06 15:52 GMT-4 Version 4.3 1 Reply

Mahder Tewolde
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

When modelling 2D heat conduction and using a heat flux boundary condition, the input allowed by comsol in SI units is W/m^2. Does this mean, that X watts/ m of x and 1m of Z? If a 2D model is assuming that the z dimension is infinite, then this could be the case? but what if the z dimension is very small and negligible?
1 Reply Last Post 2012/08/06 22:16 GMT-4
Nagi Elabbasi Facebook Reality Labs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012/08/06 22:16 GMT-4
In 2D heat transfer COMSOL assumes a thickness of 1.0 and no heat transfer through that thickness. In that case the ratio of the thickness to the in-plane dimensions is irrelevant (provided that you input all heat transfer/generation terms per unit thickness).

Nagi Elabbasi
Veryst Engineering
In 2D heat transfer COMSOL assumes a thickness of 1.0 and no heat transfer through that thickness. In that case the ratio of the thickness to the in-plane dimensions is irrelevant (provided that you input all heat transfer/generation terms per unit thickness). Nagi Elabbasi Veryst Engineering

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content