Menu

Discussion Forum

New Discussion
フィルター

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Multilayer thin film

Posted 2012/09/14 14:00 GMT-4 Chemical Reaction Engineering 1 Reply

K B
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi
I want to create a multilayer thin film and want to put boundary (diffusion) condition at the interface between two layer. How could I proceed with that ? Any help would be appreciated
1 Reply Last Post 2012/09/15 5:39 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012/09/15 5:39 GMT-4
Hi

the easiest way to make thin layer, is to use the rectangle function and add "layers" in the specific layer node, one thickness per layer.

Then you apply your model BCs as needed

--
Good luck
Ivar
Hi the easiest way to make thin layer, is to use the rectangle function and add "layers" in the specific layer node, one thickness per layer. Then you apply your model BCs as needed -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content