Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Transmission Analysis of a photonic crystal filter
Posted 2013/09/27 8:01 GMT-4 0 Replies
Please login with a confirmed email address before reporting spam
I'm analyzing a structure made of a slab photonic crystal , connected to 2 ridge waveguides.
To find the band gap (a range of frequencies of very low transmission), I have to compute transmission. For that, I use S-parameters, setting the 2 sides as ports.
To find the fundamental (highest effective index mode) mode field profile in the waveguide (to use as input for the boundary conditions), I do 2 Boundary Mode Analysis (BMA), one for each port.
I don't know if there are problems because just one of the BMA can be the ruling application mode.
However, when I do a In-Plane, stationary simulation for Harmonic Propagation, "I get error message 7248, undefined value found" on the left edge, the one of the input port.
Do you have any ideas?
Thank you in advance
Attachments:
Hello Massimo Valerio Preite
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.