アプリケーションギャラリ

This model shows how to simulate carburization and quenching of a steel gear. Diffusion of carbon into the surface of the gear affects the onset of martensitic transformation. Residual stresses are computed, and it is shown that high residual compressive stresses appear at the root of ... 詳細を見る

現代の集積回路は, プラスチック封止型マイクロ回路（PEM）として提供されています. これらのデバイスは, 内部の半導体を保護するために, ポリマー材料とエポキシ樹脂で成形されています. しかし, ポリマーモールドコンパウンドは湿度の高い環境にさらされると水分を吸収し, 膨張して望ましくない歪みを引き起こします. この歪みは, 熱歪みと同程度の大きさになる場合があります. このアプリケーションでは, MEMS圧力センサーを保護するモールドコンパウンドを介した水分の拡散について調査します. 水分拡散によって引き起こされる吸湿膨張は, ... 詳細を見る

In this example, a tensile test is simulated at four different strain rates. The Johnson–Cook hardening law is used to model the strain rate dependency of the plastic hardening. The temperature distribution and thermal expansion caused by the heating generated by the plastic ... 詳細を見る

This model presents a practical and efficient method to compute the sound transmission loss (STL) through a building component, specifically this example treats the case of a concrete wall. The method used here is valid as long as the component has little influence on the acoustic field ... 詳細を見る

Oxide jacking is the process by which reinforced concrete cracks, due to the corrosion of the reinforcing rebar rods. The corrosion process causes growth of an oxide layer on the rebar, which in turn causes internal stresses in the concrete. If the corrosion process is allowed to ... 詳細を見る

This model exemplifies the analysis of strong wind flow around a solar panel and the corresponding structural displacement due to the wind's load. The solar panel is located in an array of equally spaced identical panels, which allows for the assumption that the periodic flow conditions ... 詳細を見る

This example solves the problem of finding the optimal thickness profile of a flywheel, so that the moment of inertia is maximized without increasing the mass or the maximum stress in the flywheel. 詳細を見る

Experiments on dry and wet soil samples are performed to understand their behavior under different loading conditions. In this example, the Extended Barcelona Basic (BBMx) soil model is used to simulate the wetting and drying paths in partially saturated soil samples under cyclic ... 詳細を見る

This tutorial illustrates how to use a reduced order model to compute the response of a structure subjected to three simultaneous loads having independent time histories. Reduced order models provide an efficient way to analyze problems within linear structural dynamics. 詳細を見る

This model shows how to compute the anchor loss limited quality factor of a diamond disc resonator. The resonator is anchored to the substrate by a polysilicon post and power is transmitted to the substrate through the post. A perfectly matched layer is used to represent the essentially ... 詳細を見る