アプリケーションギャラリ

This example models the desalination of water by capacitive deionization in a "flow-between" cell (fbCDI). The model geometry is in 2D. Steady Brinkman flow, a tertiary current distribution, and the improved modified Donnan description of the deionization process is assumed. 詳細を見る

蓄熱ユニットは, 太陽熱, 地熱, または廃熱源からの熱エネルギーを蓄積するために使用されます. 最もシンプルなユニットは, 家庭でよく見られる水タンクで構成され, 太陽エネルギーを検知可能熱として蓄えます. これらのタンクの熱容量は潜熱を蓄えることでさらに増加し, 潜熱蓄熱（LHS）ユニットとして利用されます. 通常, LHSタンクには, 相変化物質としてパラフィンが充填された球状カプセルが内蔵されています. この例では, 充填ベッド蓄熱タンク内の流れをモデル化し, 相変化を伴う熱伝達とLHSユニットへの充填時の局所的な熱非平衡の影響を考慮しています. 詳細を見る

This model uses the Reacting Flow multiphysics interface to simulate a methane steam reformer. The model accounts for the interactions between the chemical reactions, the transport of species, the fluid flow, and the heat transfer in a porous medium. 詳細を見る

In this model of an ammonia-fed solid oxide fuel cell, the required hydrogen is supplied through endothermic thermal decomposition of ammonia. The model includes the full coupling between the mass balances and gas flow in the H2 and O2 gas diffusion electrodes, the momentum balances in ... 詳細を見る

In this example water ponded in a ring on the ground moves into a relatively dry soil column and carries a chemical with it. As it moves through the variably saturated soil column, the chemical attaches to solid particles, slowing the solute transport relative to the water. Additionally ... 詳細を見る

This example models an oil reservoir with two horizontal wells. The reservoir contains two phases, water and oil. Oil is recovered by injecting water through the bottom well, so the oil production rate and the water-oil production ratio over time are computed. 詳細を見る

This model illustrates the effect of oxygen and hydrogen formation and recombination on the performance and self-discharge of an electrochemical capacitor with a water-based electrolyte. A load cycle consisting of mixed constant current pulses and rest periods at an open circuit is ... 詳細を見る

This example shows the modeling of a resin transfer molding (RTM) process for a wind turbine blade using the Two-Phase Flow, Level Set, Brinkman Equations interface. Resin is injected into a preform consisting of different composites with different anisotropic permeabilities. 詳細を見る

Deposition of metallic lithium on the negative electrode in preference to lithium intercalation is known to be a capacity loss and safety concern for lithium-ion batteries. Harsh charge conditions such as high currents (fast charging) and/or low temperatures can lead to lithium plating. ... 詳細を見る

In a polymer electrolyte membrane fuel cell (PEMFC), water is produced at the cathode. The cell is also fed with water vapor via the inlet gas streams, in order to keep the polymer electrolyte membrane humidified. If the water partial pressure in the gas phase exceeds the vapor ... 詳細を見る