技術情報とプレゼンテーション

Convective transport of macromolecules or micro and nanoparticles in microsystems are usually predicted by solving the Navier Stokes equations for the carrier fluid and a concentration equation for the diffusing species. In the case of isolated particles or complicated geometries with ... 詳細を見る

Atomic layer deposition(ALD) is one proven method to deposit ultra-thin films. ALD is advantageous for its atomic-level thickness control and conformity; leading to high quality films. Slow deposition rates for conventional ALD contribute to the impracticality of utilization of this ... 詳細を見る

The research documented herein was funded by a research contract between the Research Reactors Division (RRD) of Oak Ridge National Laboratory (ORNL) and the University of Tennessee, Knoxville (UTK) Mechanical, Aerospace and Biomedical Engineering Department (MABE). The research was ... 詳細を見る

Divertor is act as an exhaust for the nuclear fusion reactor. Main function of a divertor is to remove the heat flux from the plasma. Plasma facing components of the divertor are made up of Carbon (Graphite/CFC) and tungsten like materials[1]. Hence these materials are exposed to the ... 詳細を見る

We investigate a prototype concept of a back-up electricity device where we use liquid formic acid (FA) to produce a mixture of carbon dioxide (CO2) and hydrogen (H2) which is used in a PEM fuel cell, Fig. 1. In the fluidized bed reactor the liquid FA is decomposed to a gaseous mixture ... 詳細を見る

Recently, increasing availability of natural gas, due to the shale gas, raises the attention to the conversion of methane. Methanol-to-Hydrocarbons reaction (MTH) plays an important role in this route where methanol synthesized through syngas is converted into hydrocarbons, such as ... 詳細を見る

Hydrogen has great potential to be the fuel of the future through utilization in fuel cells, but it is rarely found naturally and must be produced in energy-intensive processes. Steam reforming, the process of heating natural gas and steam in the presence of a catalyst to drive a ... 詳細を見る

In a water based electrolytic polishing process, the formation of molecular hydrogen at the cathode is unavoidable and it can contribute to the formation of surface defects at the anode side. This paper presents the work to model and simulate the molecular hydrogen flow inside radio ... 詳細を見る

Fault Current Limiters (FCLs) are expected to play an important role in the protection of future power systems due to the rising levels of the short-circuit currents. The inductive FCLs, comprising magnetic cores and one or more dc and ac windings, are particularly interesting because ... 詳細を見る

It was suggested long ago that a theoretical model of a near-cathode region in a DC glow discharge admits multiple steady-state solutions describing different modes of currrent transfer. Even the most simple self-consistent models should admit such multiple solutions. In the present ... 詳細を見る