技術情報とプレゼンテーション

We have modeled surface acoustic wave (SAW) devices composed of piezoelectric materials: aluminum nitride (AlN), lithium niobate (LiNbO3), and quartz. These materials are often used in RF filters and wireless sensors, which require temperature compensation for stability. Using our COMSOL ... 詳細を見る

Pipeline inspection tools present some limitations related to power supply which require recharging after each operation. Using batteries or tethered tools make the duration to inspect any pipeline very limited and time consuming. This paper aims at designing a spherical self-recharging ... 詳細を見る

Greenhouses need heating supply most of the time of a year. Their heating demands are high and economical heating systems are very important for this kind of facilities. Horizontal ground source heat pump systems are getting more interest last years for being easy to apply and low ... 詳細を見る

Piezoresistive pressure sensors have received much attention over the years because of low cost, simple measurement techniques, etc. There is a challenge in design with respect to appropriate positioning, shape and temperature compensation. Different models of piezoresistive pressure ... 詳細を見る

A device for monitoring the oxygen consumption of cells has been developed, which consists of two parts; a cell culturing platform (CCP) and an oxygen sensing chip. The CCP possesses inlet and outlet pipes to direct the fluid under the test to the cell culturing chamber through the inlet ... 詳細を見る

This paper summarizes the main features of the on-interposer micro-thermoelectric sensors (hereafter denoted by µTES) derived by means of simulations done with COMSOL Multiphysics® software. µTES are thermal sensors based on the Seebeck effect which converts thermal flow into electrical ... 詳細を見る

This paper reports the structural solid mechanic simulation of a MEMS out-of-plane platform that provides thermal and electrical isolation for a device built on it. When assemble, the platform lifted for approximately 400 μm above the substrate level. A mechanical stress analysis is then ... 詳細を見る

Introduction: RFID system uses a Transponder and the near field communication (NFC) antenna and a matching circuit (Figure-1) in which at least latter two must be optimally designed for a higher efficiency. Typically, RFID antennas are flat inductive coils with 2 to 4 turns and are ... 詳細を見る

Introduction: This work presents the design of a novel flow cell based miniaturized electrochemical respirometer to monitor organic content in water samples semi-continuously, in contrast to current Biochemical Oxygen Demand, BOD, methods. Simulation techniques has been used to ... 詳細を見る

At present, a great deal of research effort has been directed to find eco-friendly and renewable sources of energy. With the rising costs of crude oil and petroleum, along with the derogatory effects that they pose to the environment, this sort of approach is of utmost importance. This ... 詳細を見る