アプリケーションギャラリ

Helmholtz resonators are used in exhaust systems, as they can attenuate a specific narrow frequency band. The presence of a flow in the system alters the acoustic properties of the resonator and the transmission loss of the subsystem. In this tutorial model, a Helmholtz resonator is ... 詳細を見る

超音波流量計は, 流れに対して斜めに超音波信号を送信することで, パイプを流れる流体の速度を測定します. 流れがない場合, 送信機と受信機間の伝送時間は, 上流方向と下流方向に送信される信号で同じです. 流れがない場合, 下流に伝播する波は上流に伝播する波よりも速く移動するため, これを利用して流れを判定できます. 多くの場合, 超音波の送受信には圧電トランスデューサーが使用されます. このチュートリアルでは, 簡略化された流れがない場合のケースで, 圧電トランスデューサーを使用した超音波流量計のシミュレーション方法を説明します. モデルは, ... 詳細を見る

In this example, a simplified micromechanical model of a unit cell with periodic boundary conditions is analyzed. The homogenized elastic and thermal properties of a composite material are computed based on individual properties of fiber and matrix. A comparison of numerical values are ... 詳細を見る

This model analyzes the frequency response of a fuel tank partially filled with fluid. The tank is submitted to a vertical acceleration. Two modeling methods are considered to represent the fluid: a traditional method of smearing the mass of the fluid through the wetted surface of the ... 詳細を見る

This model presents a practical and efficient method to compute the sound transmission loss (STL) through a building component, specifically this example treats the case of a concrete wall. The method used here is valid as long as the component has little influence on the acoustic field ... 詳細を見る

In a cooling system, a microelectronic component has been identified as the critical link. Since the power is repeatedly switched on and off, the component is subjected to thermal cycling. As a results a crack grows through a solder joint and disconnects the chip from the printed circuit ... 詳細を見る

Interfacial failure or delamination in a composite material can be simulated with a cohesive zone model (CZM). A key ingredient of a cohesive zone model is a traction-separation law that describes the softening in the cohesive zone near the delamination tip. This example shows the ... 詳細を見る

In this example, a benchmark problem in dynamic fracture of brittle materials is analyzed using the AT1 phase-field damage model. An instantaneous tensile load is applied to a planar tension specimen with a pre-existing crack. Initially, the crack propagates perpendicular to the loading ... 詳細を見る

Headphones are closely coupled to the ear, and so it is not possible to measure their sensitivity in a classical acoustic free-field setup used for loudspeakers. The measurement requires the use of artificial heads and ears to accurately represent the usage conditions. This model shows ... 詳細を見る

このモデルでは, ベルリンコンツェルトハウスの小ホールの音響を音線追跡でシミュレートします. 部屋の完全な調査は, 1/3オクターブバンドで, 10組の音源受信機の位置で行われます. 部屋の音響パラメーターは, 計算されたインパルス応答から導出され, その結果は, 部屋の音響シミュレーションに関するラウンドロビン研究の測定データと比較されます. 詳細を見る